Sand Or Strip Old Hardwood Floors

I hadn t really considered that you should use multiple grits to sand your floor but your advice to start with the most abrasive grit and work down to the finer grits makes perfect sense and should give us a wonderful finish to work.

Sand or strip old hardwood floors. If your hardwood floor is only lightly worn damaged or scratched you may be able to refinish it without sanding. Use a detail sander fitted with 36 grit sandpaper to remove the old finish under places the large sander couldn t reach such as under the toekick and in corners. Store and dispose of oil soaked rags properly. Refinishing hardwood floors is the right solution.

If the finish on your wood floor is worn and lightly scratched you can make it look like new without the labor mess and expense of sanding off the finish. Flooring experts estimate that hardwood floors can be sanded for refinishing up to 10 times depending on the thoroughness of the sanding and the level of wear and tear on the floor. You can also use a chemical to etch the existing finish then apply new finish. Buffing or abrading the existing coat before refinishing or alternatively applying a chemical etching kit.

There are two basic methods. This story will show you how to refinish hardwood floors and add a new coat of finish directly over the old by first applying a liquid that roughens the old finish so the new finish can. But often that s the wrong solution. It s available in both satin and glossy finishes.

Another good to know products like these that were created to refresh floors without sanding have a thick consistency that will fill light scratches and soften small dings. Before you start sanding remove everything from the room and vacuum the floor. All wood floors are protected by a clear coating that eventually becomes scratched scuffed and dull. Rejuvenate wood floor restorer.

The best way to refinish wood floors without sanding is to scuff the floor with a buffer and sanding screen then apply two coats of new finish. When cleaning and reviving an old hardwood floor sand only if it s so heavily stained that screening or chemical stripping aren t options. This stuff is created to restore previously sealed old hardwood woods. Change the 60 grit disks to 80 grit and sand the floor one final time.

When a wood floor loses its luster the usual solution is to sand it down to raw wood and completely refinish it. Situations differ but you may not be able to refinish your hardwood floor more than 10 times. However the first method gives better results. Change the disks on the random orbit sander to 60 grit abrasive and sand entire floor.

There s a limit to how much wood you can remove without permanently damaging the floor. Rachel frampton august 6 2018 at 1 54 pm. Sanding the floor will kick up a lot of dust so protect light fixtures and tape over electrical outlets. We ve been wanting to refinish our old hardwood floors and really liked your advice on how to use grit sequencing.